My first magnetic weight issue

Post here for issues to do with sizing and finding the right size weight

Moderators: bobbyballsack, DaveSmith, tundraman

Posts: 27
Joined: July 15th, 2018, 4:23 pm
Time stretching?: 3 months
Stretching usage: Welded steel rings. OxBalls ball bender
Stretching intensity: 8-10 hours a day. Sometimes overnight
Your relationship status: Married (officially or otherwise)
Are you pierced?: No
Height and weight: 5’8”, 165
age: 51

My first magnetic weight issue

Postby Lowercapecod » September 19th, 2018, 11:34 pm

So i have finally bought a magnetic ring weight. I went with the smaller weight, glad i did. I have been using metal rings to stretch, and had good luck...up to 7! I had the worst time getting my new toy on. I finally decided to put on two metal rings on, then put the magnetic ring between the two...perfect! Plenty of Shea lotion and enjoying the weight finally. Anyone else with this experience?

Posts: 75
Joined: November 14th, 2017, 6:06 am
Time stretching?: 4 weeks
Stretching usage: WMC Donut Ball Weight
Your hang: 30mm
Stretching intensity: Few hours
Your relationship status: Married (officially or otherwise)
Are you pierced?: No
Height and weight: 5 feet 6 inch
Other sexual practices: I explore prostate massager for two month

Re: My first magnetic weight issue

Postby Dchen78998 » October 21st, 2018, 1:12 am

No I tried magnetic Cock ring before and I don’t like it because there is magnetic force when you are to attach together and once you are at certain force the attaching piece can go on air for a few second which lead to possible pinching

Posts: 7
Joined: October 1st, 2018, 1:54 pm
Sexuality: Bisexual
Time stretching?: 1 week
Stretching usage: Magnetic ballstretcher,
39mm inside diameter,
Your hang: 6cm
Stretching intensity: 5hours per day
Are you pierced?: No
Height and weight: 6ft 180lbs

How to not get nipped,!!

Postby VelezRu » October 21st, 2018, 3:29 pm

I know I am a newbie, but my ring is a magnetic one.
I do not shave, so I have hair to contend with too.!!
The ring is spilt into 3/4 and 1/4 pieces.
- I push all the skin into the 3/4 piece,
- then while holding it in with one hand/finger,
- I slide the 1/4 piece on to one side,
- facing outwards.
- Then making sure your skin and hair is inside the ring and away from the exposed 3/4 end,
- rotate the 1/4 piece into place.
- the first joint will only rotate, as the magnets will hold the join together as long as you are rotating and not pushing it sideways.
It will snap into place when it is about 3mm away.
Just make sure that there is no outward pressure against the 1/4 piece as you rotate it as you might get nipped at the first joint.
I realise this might not work if you are along side another weight.
Just, take it easy,!!

Return to “Finding the right size weight”

Who is online

Users browsing this forum: No registered users and 1 guest