Page 1 of 1

"Between Sizes?"

Posted: November 26th, 2015, 6:11 am
by SnowMutt
Yo, so I've had a weight for about a year now.

My testes are average or small, but my sac is very plump and loose. It's difficult for me to put on and wear a tighter ID because of my sac, but it's harder for me wear a looser one because I feel like I'm constantly on the verge of a slip, especially since my testes tend to "shrink" to the size of a couple shelled almonds while under the pressure of the weight for an hour or so, and I have experienced two slips already, even under short term stretching. My sac usually creates enough girth that it doesn't slip but... Sometimes... :\

My current weight is about one pound. I had originally picked up a 34 ID but it was cutting off circulation to my nuts, so I swapped it out for a 36 ID and for the most part, it works. I use organic cocoa butter and organic shea to moisturize my entire sac.

Is there something I can do to fix this? Does anyone else have this same problem?

Re: "Between Sizes?"

Posted: November 27th, 2015, 12:52 pm
by tundraman
Try washing your sac morning and evening and applying only the shea very lightly. It should virtually all be absorbed in about 15 minutes leaving just enough to prevent the ring actually sticking. This, being less slick, will slow the rate at which the ring works it's way down fully onto your testes. Then every couple hours slide the ring back up your hang so that your teste get frequent breaks from the compressive force.
Myself, with only one teste, have to do this and use a thin sleeve to add skin traction and slightly reduce effective ID by about 1 mm.
Link to the sleeve: viewtopic.php?f=2&t=160

Re: "Between Sizes?"

Posted: April 6th, 2016, 3:58 pm
by Wantone
Hey guys,
I need a 29mm dia ring, anyone help? Got one? Where can I get one?
PM me please

Re: "Between Sizes?"

Posted: July 9th, 2016, 1:51 pm
by reefknot
Although I have only been wearing my rings for a day, there is already space developing, so am looking at how I can engineer a tensioning device (I am engineer :P )